Automatic screw machine rotary or rotary cylinder was used, increase production efficiency, 2-16 shaft up to, design transverse and inclined to and multi direction and at the same time lock pay, to meet the different needs of production design and flexible production line and achieve unmanned production requirements can be added the detection function (such as: slided, floating lock, lock leakage) to ensure that the quality of the reliability of multi axis automatic locking screws minimum distance: 25mm, Max hole distance unlimited, lock pay efficiency can be according to customer requirements for debugging, the province.
General industrial products, to tighten the screws, if it is a manual operation, spend time and effort, and now mobile ultra-thin, ultra-thin tablet computers, cameras and other electronic products screws are fine, as big as ant eggs seems to be use a magnifying glass to see clearly, but these products to lock screw torque and speed requirements is also very high, if artificial to lock screw can be quite difficult, almost could not be completed. Automatic machine, can be "a few seconds to lock a few screws" speed to operate. Efficiency increased by several times, according to the different needs of different products, automatic screw machine torque, speed can be adjusted.
Automatic screw machine according to the customer production line of special production requirements for the design of the lock to pay the feeding station, the completion of the automatic feeding and at the same time to tighten the screws and other procedures. In theory, most of the use of screws or small cylindrical parts, assembly of the occasions are suitable for the use of automatic lock screw machine. Automatic screw machine of the new mode of production concept is the principle of profit as the driving force of promoting enterprise reform, in today's belong to the free market competition environment, in order to achieve the goal of profit must try to to achieve the target cost. So how to adjust the screw machine is how to adjust the screw?